Sata Settings Screen; Boot Settings Screen - Dell PowerEdge R810 Owner's Manual

Hardware owner's manual
Hide thumbs Also See for PowerEdge R810:
Table of Contents

Advertisement

Option
C1E
(Enabled default)
C States
(Disabled default)
Processor X Family-
Model-Stepping

SATA Settings Screen

Option
Embedded SATA
(Off default)
Port A
(Off default)

Boot Settings Screen

Option
Boot Mode
(BIOS default)
Boot Sequence
Description
When set to Enabled, the processor(s) can switch to a
minimum performance state when idle.
When set to Enabled, the processor can operate in all
available power states.
Displays the family and model number of each processor.
A submenu displays the core speed, the amount of cache
memory, and the number of cores of the processor(s).
Description
ATA Mode enables the integrated SATA controller. Off
disables the controller.
Auto enables BIOS support for the device attached to
SATA port A. Off disables BIOS support for the device.
Description
CAUTION:
the system from booting if the operating system was
not installed in the same boot mode.
If the system operating system supports Unified
Extensible Firmware Interface, you can set this option to
UEFI. Setting this field to BIOS allows compatibility
with non-UEFI operating systems.
NOTE:
Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
If Boot Mode is set to BIOS, this field tells the system
where the operating system files needed for startup are
located. If Boot Mode is set to UEFI, you can access the
UEFI boot manager utility by rebooting the system and
pressing <F11> when prompted to do so.
Using the System Setup Program and UEFI Boot Manager
Switching the boot mode could prevent
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents