About Track Numbers - Sharp MD-MT290H Operation Manual

! About track numbers

1. Track numbers are created automatically during re-
cording via the analogue connection when a silence of
1 second or more is detected (auto marker function).
A series of tracks can be recorded as one by disabling
the auto marker function (see page 26).
About
1 second
Silence
First track Second track
2. When recording from a CD or a MiniDisc using the dig-
ital connection, track numbers will be created at the
same points as on the CD or MiniDisc (synchro mark-
er function).
First track Second track Third track
Playback
side Track A Track B
First track Second track
Recording
side Track A Track B
" Track numbers may not be created in proper places,
depending on the source to be recorded from, such as
signals with noise.
" The track numbers on the playback side may not
match the track numbers recorded on the MiniDisc.
" When recording, if a programmed playback is per-
formed by the source or playback is performed by
selecting tracks manually, the MiniDisc track numbers
may not be the same as on the source.
" Track numbers may not be created properly, depend-
ing on the connected stereo system.
! About sampling rate converter
This portable MD incorporates a sampling rate converter
so that it can record from digital radios or DAT tape
recorders.
! Note for digital recording
You cannot copy a MiniDisc that you recorded from digital
inputs to another MiniDisc or DAT. It is prevented by the
SCMS (Serial Copy Management System). Recording
from analogue inputs is not affected.
Digital signals Digitally recorded
Track C
MiniDisc
CD player,
Third track
MiniDisc
Track C
player,
Digital
etc.
connection
02/12/18
MD-MT290H
Cannot record
Digital
connection
27
MD_MT290H_UK_4.fm
6
5
4
3
2
1