Table of Contents
Advertisement
Before Recording
About the TOC
After any recording or editing function, "TOC" (Table Of
Contents) is displayed. To finalise the recording or editing
function, turn the power off. During this process, "TOC"
will flash and "TOC EDIT!" will be displayed. During any
recording or editing function, the MiniDisc unit lid is
locked, and the MiniDisc cannot be removed until the
process is finalised.
TOC display
Warning:
If the power is removed (Battery/AC adaptor) whilst
"TOC" is displayed, the MiniDisc unit lid will remain
locked until the battery/main power is restored and
the unit is turned on. Your new recordings or edited
changes will be lost and your MiniDisc may become
unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the
instructions below.
-
Do not jerk or bump the unit.
-
Do not unplug the AC adaptor.
-
Do not remove the battery.
-
Do not subject the unit to shock.
Otherwise, tracks may not be recorded properly.
To prevent recorded MiniDiscs from
being erased accidentally
Slide the accidental erase prevention tab, located on the
side of the MiniDisc, in the direction indicated by the
arrow.
The MiniDisc will then be protected against accidental
erasure.
Recording
Recordable
prevented
To add a recording to such a MiniDisc, slide the acciden-
tal erase prevention tab back to its original position.
Helpful tip when attaching a label
When attaching a label to a MiniDisc cartridge, be sure to
note the following. If the label is not attached properly,
the MiniDisc may jam inside the unit and you may not be
able to remove it.
If the label peels off or partially lifts
away, replace it with a new one.
Do not put a new label on top of an ex-
isting one.
Attach the label only in the specified
location.
02/12/18
MD_MT290H_UK_2.fm
MD-MT290H
6
5
4
3
2
1
15
Hide quick links:
Advertisement
Table of Contents
