Sharp MD-MT290H Operation Manual page 29

! Sound-actuated recording
(Mic Synchronised recording)
1
Press the REC button.
2
Press the REC LEVEL or button to ad-
just the recording level.
3
Select the recording mode (steps 5 - 9, page
17).
4
Press the MENU/ENTER button.
5
Press the or button repeatedly to se-
lect "SYNC ON".
6
Press the MENU/ENTER button.
7
Press the or button to select the re-
cording start level.
MIC SYNC H :Recording starts when the unit detects
- 24 dB or more (the unit can start re-
cording from quiet sounds).
MIC SYNC L : Recording starts when the unit detects
- 12 dB or more.
8
Press the MENU/ENTER button.
9
When a sound, such as person speaking, is
picked up by the microphone, recording will
begin automatically.
About pause function
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(Pause function does not work for approximately 10 sec-
onds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
Notes:
" Whilst making a mic recording, do not connect any-
thing to the OPTICAL/LINE IN socket on the portable
MD.
" To use a microphone, be sure it is a plug-in-power
type microphone.
- When a plug-in-power type microphone is plugged in,
the portable MD will provide power for the micro-
phone's operation.
- If a different type of microphone is plugged in, it may
not operate properly or it may cause the unit to mal-
function.
" Insert the plug firmly. If you don't, the recording will not
be made properly.
" Use a microphone with a 3.5 mm (1/8") diameter
stereo mini plug.
" If the unit starts recording too often from low unwanted
noises, set the microphone input to "MIC SYNC L".
" Recording sensitivity can be changed whilst recording.
02/12/18 MD_MT290H_UK_4.fm
MD-MT290H
6
5
4
3
2
1
29