Renkus-Heinz Iconyx IC8-R User Manual page 7

the top of the lower one and the bottom of the upper one are close to one
Insert the free end of the short ribbon cable into the socket on the second
module. Using a #1 Phillips screw driver, secure the connector with two
are not seated properly, you may have to disassemble the column again
in order to seat them correctly.
Align the two modules and slide them together, making sure the holes
in the heavy joining plates align with the holes in the modules. Install the
remaining screws into the joining plates and tighten all the screws. The
assembly is now complete.
Important: The IC16/8-R and IC323/16-R require slightly different
cabling between the modules.
IC16/8-R
This requires different connections between the two modules. In the
Master module.
1.
2. Locate and pull out the 8-conductor loudspeaker connecting cable in
3. Pug the 8-conductor loudspeaker connecting cable into the 8-pin con-
4. Finish the mechanical assembly.
Note that you do not have to connect the upper module's power and rib-
bon cables to the lower module.
IC32/16-R
The procedure is the same except that
1. The 8-conductor loudspeaker cable needs to be connected between the Master module and the second
module and between the third and fourth modules.
2. The power and the ribbon cables need to be used to connect all four modules together.
Users Manual
Figure 1
Figure 2
Figure 3
IC-R
7