Renkus-Heinz Iconyx IC8-R User Manual page 35

On the right side of the Control Properties window, in the upper dark grey section, you will see a frequency response graph. Underneath it
with controls for corner frequency and boost/cut.
Bandwidth, Frequency, etc.
the Bypass button is red and the Gain Reduction meter on the right side of this section lights up. To turn the compressor off or compare the
uncompressed output, click the Bypass button.
pressed signal to those expected of the signal pre-compression. It has a range of 0 to +12 dB.
you are using 96 kHz.. Use either the up-down arrows or the slider control to adjust the delay time.
IC-R
Users Manual
-
-
35