Renkus-Heinz Iconyx IC8-R User Manual page 22

IC-R
Users Manual
The next step is to connect the
CobraNet Receivers in the RHAON
loudspeakers. Double click on one
and then double click on one of the
loudspeaker's red Rx triangles to
connect the two. A connection line
will let you know the connection
was completed. The loudspeaker's
Receiver automatically inherits
Transmitter. Keep repeating these
steps until all the loudspeakers are
connected.
To correct a mistake or change an
assignment, click on the Receiver
whose assignment you want to
change to select it or right-click on
the Receiver Icon and select Disable
Receiver from the menu that pops
up. Either method will break the con-
nection and allow you to make a new one.
carry 8 channels of digital audio,
you must make channel selections
individually.
Once your Tx and Rx bundle assign-
ments have been made, open each
loudspeaker's Properties window by
double-clicking its icon. If the window
does not open in Connect mode,
click on the Connect tab at the top
to display the window shown at the
right.
In the lower-right section of this win-
dow, you make channel assignments
by clicking and dragging to connect
audio channels from the CobraNet
source to the RHAON loudspeaker's
CobraNet Receivers.
-
braNet Transmitters.
22