Renkus-Heinz Iconyx IC8-R User Manual page 6

IC-R
Users Manual
Prepare an assembly area. Each module is 4 feet long, so
IC16-R and 16 feet for an IC32-R. We suggest covering the
assembly area with a heavy cloth or some other soft material
sembling them. Avoid resting the modules on their grille. The
modules are heavy and may deform the grille. Instead, rest
the modules on their sides or back.
Place the modules in their respective positions on the as-
sembly area.
Note: Be aware that If you purchased two or more IC8-R
arrays at different times and now want to turn them into an
IC16-R or larger array, the IC8-R array modules must be of
the same Firmware version. Firmware version 1.x must not be
mixed with Firmware version 2.x. Refer to page 58 for details
the bottom of the top module, and the tops and bottoms of
any intermediate modules and their mounting brackets.
To remove an end cap, remove the eight machine screws
from each side of the cabinet and lift the end cap and its
mounting brackets out of the cabinet. Note that for clarity the
end cap was removed in the graphic.
Now, use the mounting bracket machine screws you removed
to install the two heavy joining plates. They will be packed
with the hardware.
Tighten the screws lightly. The joining plates need to be a little
loose to slide easily into the other cabinet.
provided. It only goes into the socket one way and the cable
is reversible. It does not matter which end goes into which
module. Make sure the connector is fully seated and then
secure the connector Using a #1 Phillips screw driver and the
Plug one end of the 3 conductor AC cable into its mating
socket. Make sure it is properly seated.
6
-