Renkus-Heinz Iconyx IC8-R User Manual page 25

IC-R
Users Manual
default measurement system is feet but you may want to
use meters.
To check or change the setting, right click in the center of
the beam steering window or select Preferences from the
Options pull down menu in the tool bar section of RHAON
window. If you want to change from feet to meters, click in
the Metric radio button.
Note that this window also allows you to control the
behavior of the Fault Relay and the Power-On sequenc-
ing delay.
normal default setting are shown.
This setup window also allows you to change the height
more familiar with the program we suggest you accept
the default setting. There are times, however, when you
will want to change the height of the measuring plane. It
audience, but not for a standing audience.
The Mapping Appearance section allows you to control
the appearance of the main Mapping plot. For now, we
suggest using the default settings. You can experiment
with various settings later.
scales used in the main Mapping window.
Many experienced users like to use the Fixed Range
with this to see which settings you like best. We used the
Fixed Range option for the displays in this manual.
We'll investigate the other tabs later.
25