Renkus-Heinz Iconyx IC8-R User Manual page 21

CobraNet Signal Routing
nels per bundle can vary, depending on settings for latency and resolution. The number of bundles available depends on network band-
width.
Each CobraNet bundle has a number from the following ranges:
0: Disables the receiver or transmitter.
In order for CobraNet devices to communicate,
numbers must match. RHAON devices are
equipped with two receivers and two transmit-
ters, their bundle numbers must be assigned
correctly so they can send and receive audio via
the network. RHAON software makes this easy.
In most cases the settings of a CobraNet source
will have already been established with the
source's own proprietary software and can be
changed only with the manufacturer's software..
However, it the manufacturer's software allows
you can set or reset both receiver and transmit-
ter bundle settings of any device found on the
CobraNet network using RHAON software.
Latency settings. Right clicking on the CobraNet
them.
You will then want to check the device settings
settings. The settings must be the same for the
source and for all devices connected to it.
While latency may be changed here via point-
and-click, the sample rate is pre-programmed
You can switch sample rate by uploading the
triangles on the left of its icon represent Rx bundles and the green triangles represent Tx bundles. Right clicking on one of the triangles will
open a pop up window that shows the bundle number and allows you to change it.
-
-
IC-R
Users Manual
-
21