Resetting The Lamp Operating Time - Epson EMP-735 User Manual

Maintenance

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp operating
time. When the cumulative operating time reaches a certain point, it causes the
replacement warning message to be displayed. Therefore, the counter needs to
be reset after the lamp has been replaced with a new one. You can do this using
the configuration menu.
Use the remote control to carry out the operations for resetting the lamp
operating time.
Tip :
Do not reset the lamp operating time except after the lamp has been replaced, otherwise
the lamp replacement period will not be indicated correctly.
Procedure
1
Connect the power cable, turn on
the projector's power, and then
press the [Menu] button on the
remote control.
The configuration menu will appear.
2
Select "Reset Lamp Timer" from the
"About" menu and then press the
[Enter] button.
3
Select "Yes" and then press the
[Enter] button.
The lamp operating time will then be
reset.
Lamp
Reset Lamp Timer
Video Source
Input Signal
Frequency
SYNC Polarity
SYNC Mode
Resolution
Refresh Rate
90
EMP-735 User's Guide
Remote Control
Menu A/V Mute Freeze
E-Zoom
Enter
: 1400H
: Execute
:
Computer
:
RGB
:
H ---.--kHz
:
V ---.--Hz
:
H ------
: V ------
: ------
:
0x 0
:
0.0 Hz
Reset Lamp Timer
Execute?
NO
YES