Resetting The Lamp Operating Time - Epson EMP-S4 User Manual

Maintenance

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp
operating time. When the cumulative operating time reaches a certain
point, it causes the replacement warning message to be displayed.
Therefore, the counter needs to be reset after the lamp has been replaced
with a new one. You can do this using the configuration menu.
Do not reset the lamp operating time except after the
lamp has been replaced, otherwise the lamp replacement
period will not be indicated correctly.
PROCEDURE
A
Connect the power cable and turn on the projector.
B
Select "Reset" from the configuration menu, and then
select "Reset Lamp Hours".
For details on this operation, refer to
Menu .
"
sp.32
Check the buttons you can use, and the operations they
perform, in the guide at the bottom of the screen.
Using the remote control
C
When "Execute?" appears, select "Yes".
The lamp operating time will then be reset.
61
" Using the Configuration
Using the control panel