Epson EMP-735 User Manual page 33

Adjusting the Screen Image
* This value applies when the zoom ring is turned to the maximum "T" setting.
If the zoom ring is turned to the "W" setting, the available angle of tilt for
automatic adjustment will become smaller.
Tip :
• Automatic keystone correction is not carried out when the "Rear" or "Ceiling"
commands in the "Advanced" menu are set to "ON".
• If you would like to make further adjustments after automatic keystone correction has
been carried out, you can use the [Keystone] button on the projector's control panel.
( p.33)
• When keystone correction is carried out, the projected image will become smaller.
• If the images become uneven in appearance after keystone correction is carried out,
decrease the sharpness setting. (
• If automatic keystone correction is not required, set "Auto Keystone" in the "Setting"
menu to "OFF". (
Procedure
Whilst pressing the two foot adjust
buttons at either side, lift up the
front of the projector so that the
front adjustable feet can extend.
Extend the front adjustable feet until the
desired angle is obtained, and then release
the foot adjust buttons.
To retract the front adjustable feet, gently
push down on the projector whilst
pressing the two foot adjust buttons.
Tip :
If the projector is tilted horizontally, turn the bases of the front adjustable feet to adjust
the angle.
Front adjustable
foot
Extend
p.45, 46)
p.50)
Retract
32
EMP-735 User's Guide
Foot adjust buttons (side)