Replacing Consumables; Replacing The Air Filter; Replacing The Lamp; Resetting The Lamp Operating Time - Epson EMP-TW20 User Manual

Maintenance

Replacing consumables

Replacing the air filter

Q
Tip: Dispose of used air
filters properly in ac-
cordance with your
local regulations.
Air Filter:
Polypropylene

Replacing the lamp

c
Caution:
If the lamp stops working
and needs to be re-
placed, there is the dan-
ger that the lamp may
already be broken.
If replacing the lamp of a
projector which has been
installed to the ceiling,
you should always as-
sume that the lamp is
broken and handle it with
extreme care during re-
moval. Furthermore, you
should stand to the side
of the projector, not un-
derneath it.

Resetting the lamp operating time

The lamp operating time
must always be reset after
the lamp has been replaced
with a new one.
The projector has a built-in
counter which keeps track of
the lamp operating time.
When the cumulative operat-
ing time reaches a certain
point, it causes the replace-
ment warning message to be
displayed.
42
1
Turn off the power, wait
until the projector cools
down and the "beep
beep" tone sounds, then
disconnect the power
cable.
1
Turn off the power, wait
until the projector cools
down and the "beep beep"
tone sounds, then discon-
nect the power cable.
* Wait until the lamp cools
down (takes approxi-
mately 1 hour).
6
Securely tighten the
lamp fixing screws.
1
Press to turn on
the power.
2
Remove the air filter
cover.
Put your finger under the
latch and pull it upward.
2
Remove the lamp cover.
To remove the cover, use a
screwdriver (the one supplied in
the same package as the option-
al lamp) inserted into the lamp
cover open switch.
7
I
nstall the lamp cover.
2
Press to display the
configuration menu.