Replacing The Lamp - Epson EMP-735 User Manual

Maintenance

Replacing the Lamp

Caution :
Wait until the lamp has cooled down sufficiently before opening the lamp cover. It takes a
further one hour after the cool-down
enough.
Procedure
1
Turn off the projector power, wait
for the cool-down period to end,
and then disconnect the power
cable.
The cool-down period lasts for about 45
seconds. The actual time will vary
depending on the external air temperature.
2
Wait until the lamp has cooled
down, and then remove the lamp
cover from the base of the
projector.
It takes approximately one hour for the
lamp to cool down by itself after the cool-
down period has finished.
Whilst pressing the two hooks, pull the
lamp cover up to remove it.
3
Loosen the two lamp fixing screws.
Use the screwdriver that is supplied with
the new lamp or a Phillips screwdriver to
loosen the two lamp fixing screws that are
securing the lamp to the projector.
period has finished for the lamp to be cool
88
EMP-735 User's Guide