Installing Fence; Mounting Jointer-Planer; Checking Cutter Blades And Screws - Craftsman 113.206933 Owner's Manual

1. Place fence on jointer table as shown.
2_ Locate the following parts from the loose parts bag
and install as shown.
1. CarriageBolt, 3/8-16 x 24/2
2. Retainer
3, Fiat Washer 13/32 x 13/! 6 x 1/t6
4. Spacer
5. =Knob
[E
1 2 JOINTER eASE
SPECIAL NOTE: It is a good _dea at this point to see if the
infeed table and Outfeed table are paraltel to each other. If
it is necessary to align the two tables the procedure used
to make them parallel can be more easily performed now,
before mounting the jointer/planer to the leg set, Refer to
page 14 for directions explaining how to check and align
the infeed and outfeed tables.
MOUNTING JOINTER-PLANER
1. From among the loose parts, find the following hard-
ware:
assembly
7 Lockwashers, 5/16 in. External Type
7 Washers, 11/32 ID
7 Hex Jam Nuts, 5/16-18
2 Cord Clips
2. Loosen FENCE LOCK KNOB, Tilt fence upward and
slide it toward the pulley.
3. Position machine on Leg Set and align mounting holer
in machine with holes in Leg Set letter coded "A'.
Mount with three (3) 5/16-18 x 2" Long Hex Head
Screws.
4. Place a flat washer, a tock washer and a nut on each
screw from underneath the stand and tighten.
5. Place handwheet on shaft aligning flat surfaces on
shaft with flat surfaces on handwheel.., attach with
1-1/4 in. screw.
_1_ / JOINTER ;PLANER
HEX HEAD SCREW
1
HEXNOTff'_
Jl
FENCE LOCK KNOB
4Carriage Bolts, 5/16-18 x 3/4
3 Hex Head Screws, 5/16-18 x 2
_/4-_0 TRUSS
HEAD SCREW SIDE STIFFENER
--- MOTOR SUPPORT AT THIS END
11 1
CHECKING CUTTER BLADES AND SCREWS
TOOLS NEEDED
5/32" and 1/8" Setscrew Wrenches (furnished with
Jointer).
Lead Pencil
FLAT WASHER
(AS REQUIRED) ..
LOCKWASHER
NUT ----"_
5/32 IN. SETSCREW
OUTFEED TABLE WRENCH
WEDGE
DEPTH OF CUT
EL
Short straight edge (or head of combination square)
1. Insert pencil in space at end of cutterhead to hold
cutterhead guard open.
2. Lower the infeed table with the Depth of Cut Hand-
wheel.
3. Rest the straight edge on edge on the surface of
outfeed table so it extends across the opening between
the tables, at three positions: near each end and at the
middle of the cutter blade.
4. Rotate the cutterhead by grasping the 2" dia. driven
pulley and make sureeach knife nicks (touches) the
straight edge at all three positions. If not, follow
BLADE
PENCt L
\
CUTTER GUARD
procedure under "REPLACING CUTTER BLADES"
on pgs, 19 thru 21.
8