Table of Contents
Advertisement
BEVELING
Adjust the fence to the desired angle..,
tighten fence and
guard lock knobs ......
For pieces of woo d 3" or wider hold the board firmlydown
on both tables and firmly against the fence (as illustrated)
with your hands on the side and top of the workpiece,..
keep finge_s close together.
NOTE: Removing
only the corner on the edge of a board is
known as CHAMFERING
while beveling is removing the
corner
or the edge of the board
down to the boards
surface.
Normally
a chamfer is made with one cut,.,
therefore,
a
cut deeper than 1/16 in. may be made,
For pieces of wood less than 3" wide use hold down/push
blocks (as illustrated)
on the side of the workpiece so you
can hotd the workpiece
in toward the fence at all times as
well as down against the table top.
WARNING: DO NOT CONTACT
THE CUTTING
KNIVES
OR THE GUARD WITH THE PUSH BLOCKS.
BEVELING
BOARD
WIDER
THAN
3 INCHES
CHAMFER
BEVEL
BEVELING BOARD NARROWER THAN 3 iNCHES
NOTE: Rabbeting
on a Jointer
is considered
to be a
dangerous
operation
because it requires removal of the
cutter
guard
and increases
the potential
of kickback
because of excessive depth of cut .....
NEVER ATTEMPTTO
PERFORM A RABBETING
OPERA-
TION ON THIS JOINTER. DO NOT OPERATE JOtNTER/
PLANER
WITH
CUTTERHEAD
OR BELT
GUARDS
REMOVED.
Rabbet cuts should
be made on the Radial Saw or Tabte
Saw by making two cuts with the sawblade or by using the
Dado Head or Molding
Head. Rabbet
cuts can also be
made using the Shaper or Portable Router.:
i
,
i
maintenance
RABBETCUT
::i•
IHUlhUlN
........
=
BLOCK OF WOOD
REPLACING
CUTTER
BLADES
WARNING:
FOR YOUR OWN SAFETY, TURN SWITCH
"OFF"
AND REMOVE PLUG FROM POWER SOURCE
OUTLET
BEFORE
ADJUSTING,
MAINTAINING,
OR
LUBRICATING
YOUR JOINTER-PLANER,
1. Remove be!t guard.
2. Position
fence
to right
,..
approximately
1/4 in,
beyond cutter blades..,
lock it in place,
3. Lower infeed table all the way down,
4. Place block of wood 6-3/4 in, long between
cutter-
guard and fence:
/
19
Hide quick links:
Advertisement
Table of Contents
