Craftsman 113.206933 Owner's Manual page 31

CRAFTSMAN 6-1/8 iNCH JOINTER-PLANER MODEL 113.206933
NOTE:
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS
REPAIR iS DONE BY QUALIFIED
SERVICE TECHNICIAN.
REPAIR SERVICE IS AVAILABLE
AT YOUR NEAREST SEARS STORE,
FIGURE 6 -- 67094 MOTOR PARTS LIST
Key Part
No. No.
1 60306
2 64088
3 64258
Description
Screw, 8_32 x 3/8, Thread
Cutting, Slotted, Serrated Hd.
Cover, Terminal
Cord with Plug
........ • ........................................................... , ,,,i,i,,
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT
PLUG TO POWER SOURCE OUTLET UNTIL ALL
ASSEMBLY STEPS ARE COMPLETED.
1. Open motor connector box cover located on left end
of motor (viewed from rear of saw) using a flat b_ade
screwdriver,
2. Remove GREEN SCREW and Iockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with Iockwasher between
terminal and motor frame. (See [llus_)
3. Reinsert GREEN SCREW in the threaded hole, Tighten
securely.
4. Insert terminal end of WHITE wire on spade terminal
marked T4 on the motor, Push terminal firmly until
seated.
5. Insert terminal end of BLACK wire on spade termina_
marked T1 on the motor. Push terminal firmly until
seated.
6. Close motor connector box being sure that power
cord is seated in the largest strain relief groove, and
tighten box cover screws.
TERMINAL
GREEN
INTERNAL
LOCKWASHER
GREEN WtRE
_TO GREEN SCREW
STRAIN RELIEF
)VE
WHITE WIRE TO
TERMINAL T4
IIIHI,, _ i H ........................... ii
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Legs ................................. 9-22245
FloOr Stand .............................. 9-22216
Cutter Blades .............................. 9-2293
Power Too! Know-how Handbooks
Radial Saw .............................. 9-291;
Table Saw ................................. 9o2918
Knife Setting Gauge ........................ 9-2647
Chip Collector ............................ 9-29977
The above recommended accessories are current and
were available at the time this manual was printed_
31