Fence Locks And Stops; Fence Tilt Scale - Craftsman 113.206933 Owner's Manual

_
- = FENCE LOCKS AND STOPS.= The fence can be
moved across the Jointer to take full advantage of
1he "sharpness_' Of the blades.
Thb fence should be positioned to the extreme right
(toward pulley) but not beyond the end of the
blades.
Most of the cutting (usually jointing) will be done
-. w_th thefence in this position, As the blades become
• .dull, the fence can be moved toward the left where
the blades are sharper,
To move the fence, loosen the Fence Lock Knob and
the Sliding Guard Knob and slide to desired position.
Make sure SLIDE BRACKET is even with surface of
OUTFEED TAB LE. If it is above or below the surface,
loosen screws and adjust it.
a. Always tighten fence lock knob first to align
fence, then tighten sliding guard knob.
b. Before tightening fence lock knob, hold fence
down on outfeed table so it does not rock.
c. 90 ° Fence Stop positions fence square to tables.
TO tilt fence, loosen the fence lock knob and
sliding lock knob and pull the stop out. Tilt to
desired angle and tighten both knobs.
d. To set fence at g0 ° to tables, loosen the two
knobs, tilt fence so the stop springs back into
place. Tilt fence back so the stop rests on the
table and tighten both knobs.
e. 45 ° Fence Stop positions the fence at 45 ° to the
tables.
f. To tilt fence to 45 ° loosen the two knobs, pull 90 °
stop out, t It:fence so the 45 ° stop rests on the
table.
g. Ho d fencedown on outfeed table and tighten the
twokn0bs: " " : ' : :
i i i i ii i i
. FENCE TILT SCALE. Indicates tf_e angle of the
fence to the tables. When the 90 _ fence stop is
correctly adjusted, the fence will be 90 ° to the table
and the scale will read 90 °.
To check for squareness, place an accurate square
PUSH DOWN
WHEN LOCKING
FENCE LOCK KNOB
FENCE
45°FENCE
STOf
_°FENCE
STOP
FENCE LOCK .
KNOB \
\
SLIDING GUARD KNOB
SLIDE BRACKET
._..---FENCE TILT SCALE
on infeed table and check fence while locked at 90 °
position. MAKE SURE 90 ° STOP IS AGAINST SLIDE
BRACKET.
If fence is not square to table:
a. Slightly loosen fence lock knob and guard lock
knob ....
FENCE
FACE
SQUARE
/
" CUTTER
GUARD
1NFEED
TABLE
12