Table of Contents
Advertisement
maintenance
2. Position guard as shown with;PIVOT PIN above hole
in infeedtable.
3, Align SLOT in pin With TANG
in spring, and press
down.
4i Replace cotter pin.
FENCE
IN PLACE
TANG
OF SPRING
IN CENTER
OF
HOLE
CUTTER
GUARD
'1 iii
ii
i
PIVOT PIN
5. RAISE end of FENCE, rotate guard COUNTER
clock-
wise only enough to CLEAR fence,
6. LOWER fence and tighten both knobs.
\
LI FT
COUNTER
CLOCKWISE
FENCE
=
=
The normal position
of guard (at REST) when fence is
stationed at MAXIMUM
WIDTH
OF CUT.
is shown as
"position
"A". NEVER ROTATE GUARD BEYOND POSI-
TION "B" BECAUSE THIS WOULD EXERT EXCESSIVE
TENSION
ON SPRING WHICH
COULD
WEAKEN
OR
BREAK IT.
Check operation
of GUARD and SPRING.
1. With fence
in MAXIMUM
WIDTH
OF CUT position,
pass a piece of 1/4 in, thick wood on edge (jointing
position)
over cutterhead.
2. The guard
should return automatically
to its REST
position
against the fence when free of the wood.
3. If guard does not return to its REST position,
remove
cotter
pin from pivot pin and remove guard. Check
pivot pin and hole..,
make sure there are no burrs,
rust, or other foreign matter.
4. Apply a few drops of SAE No. 20 or No, 3Oengine oil to
pivot pin.
5. Replace guard and cotter pin.
POSIT1 ON °'B"i,J
/
If guard still does not return to its REST position consult
your local Sears Retail Store before using the jointer-
:
planer.
[
MAX.
WIDTH OF
CUT
!
22
-
i:
Hide quick links:
Advertisement
Table of Contents
