Installing Fence - Craftsman 113.232210 Owner's Manual

INSTALLING FENCE
1. Rotate the cutter guard counterclockwise and place.
the fence on the jointer table as shown.
2.: Locate the following parts from the loose parts bag
and install as shown:
,
4.
One (1) 318-16 x 2-1/2 carriage bolt, one (1) retainer,
one (1) .380x 1-5/32 x 3/32 flat washer, one (1)
spacer, and one (1) knob.
Attach the fence to the jointer as illustrated below.
Rotate the cutter guard counterclockwise away from
the fence and then release it. The spnng tension on
the guard must cause it to swing back against the
fence, if the guard does not swing back against the
fence, recheck your assembly procedure. Do not
use the jointer/planer if the guard wilt not automati-
cally swing back against the fence and cover the
cutter head,
CARRIAGE
BO_
RETAINER
SPACER
FLAT WASHER
KNOB
CARRIAGE
BOW
RETAINER
SPACER
FLAT
WASHER
\
KNOB
VIEWED FROM REAR
t7
• !!!i....