Table of Contents
Advertisement
MOTOR MAINTENANCE
AND LUBRICATION
1. The bearings, in both end shields of the motor, have
been lubricated
at the factory with €orrect lubricant.
NO Other part of the motor requires lubrication.
2_ Re-lubricate
motor bearings in accordance
with the
instrgctions on the nameplate. Be sure to wipe off dirt
or grit if present around oil hole caps to prevent any
possibility
of foreign
material contaminating
the oil
wicks that supply the bearings with oil. Use a good
-grade of medium weight mineral oil, such as automo-
bile engine noii, SAE 20.
3. If disassembly of the motor is necessary,
it should be
returned to your neareast Sears retail or mail-order
store in order to prevent voiding the guarantee.
NOTE: The speed of this motor cannot be regulated or
changed.
4. Every effort shou Id be made to prevent foreign material
from entering the motor. When operated under cond|-
tions likely to permit accumulations
of dust, dirt, or
waste within the motor, a visual inspection should be
made at frequent intervals. Accumulations
of dry dust
car'; usually
be blown out successfully.
NOTE:
Motors
used on wood-working
tools are
particularly
susceptible to the accumulation of sawdust
and wood
chips
and
should
be blown
out
or
"vacuumed"
frequently
to prevent interference
with
normal motor ventilation and proper operation of the
centrifugally-operated
starting switch.
trouble shooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING
YOUR JOINTERPLANER.
TROUBLE
SHOOTING
CHART
TROUBLE
PROBABLE CAUSE
REMEDY
1. Defective On-Off switch.
1. Replace defective parts before using machine
again.
Defective switch cord.
Defective switch box
receptacle.
-
2. Motor protector open (only
2, Consult Sears Service. Any attempt to repair this motor
-
:
if your motor is equipped
may create a HAZARD unless repair is done by a
....
:
wi:th an ovedoad protector),
qualified service technician. Repair service ls available
table after passing over , below surface of outfeed table.
Ripples on planed
1, One blade set higher than
1. Re-adjust btades, see Maintenance
section.
surface,
I
other.
2. Feeding wood too fast.
2. Feed wood slower.
Planed surface not
Infeed table out of adjustment.
Re-adjust infeed table, see Getting To Know your Jointer'
straight.
,
Planer section.
Excessive gouging at
Blades set too h gh above
Reset blades, see Maintenance section.
end of cut.
outfeed table.
90 ° and 45 ° cuts
1. Fence stops not adjusted
1. Re-adjust
fence stops, see Getting To Know your
inaccurate,
properly.
Jointer Planer section+
2. Fence slide bracket not
2. Re-adjust slide bracket, see Getting To Know your
•
even with table.
Jointer Planer section.
InrOad table loose,
l l Dovetail spacer requires
1. Tighten screw, key lO, see fig, 3 Parts List.
,
adjustment,
i
2. Female dovetail loose from!
2. Tighten screws, key 17, see fig. 3, Parts List.
....
t
table.
:
i
...........
Cutter guard does not
1. Return spring brokeni
or
1 Replace spring immediately. See Maintenance
section.
function properly,
spring has been weakened_ :
:
....
"
_ ....
_ 2. improper assembly of
2. See Maintenance section.
I
spring or guard mounting.
Hide quick links:
Advertisement
Table of Contents
