Craftsman 113.206933 Owner's Manual page 21

I/8 IN, SETSCREW WRENCH
10. Insert a blade in slot marked I .,. so it projects t/16 in.
beyond end of the cutterhead,
11. "Insert a wedge next to blade so the flat side of the
wedge is against the bla(_e. Push wedge in manually
-do not install two locking setscrews at this time."
!2, Place head of square on outfeed table. Loosen lifter
screws to raise blade until it just touches square and
slightly raises it. Gently turn cutter head back and
forth with the pulley while raising blade. The blades
should be adjusted just slightly above the cutfeed
table, by approximately .003 in. (thickness of an
average piece of paper).
NOTE: Sears has a knife setting gauge for this purpose.
Cat. #9-2647
HEAD OF
SQUARE ........
OUTFEED_
LIFTER SCREW
...... ii ,lllllr,i !iN,llll ii iii i
13. "Now install both locking setscrews and tighten (with
the 5/32" setscrew wrench) alternately a little at atime.
Tighten both screws securely. Recheck the blade to
make sure it did not change position."
14. Install other two blades the same way.
INFEE
/
INSTALLING CUTTER GUARD SPRING FLAT WASHER _zSPRtNG
t. Remove cotter pin from pivot pin in cutter guard and _"-'-_ !_ SUPPORT
remove guard (located u_derneath infeed table). _ LOCK _-_ 7"_PLATE
Spring must appear as in sketch from underside of infeed WASHE R_"_.._ /
table, it will not perform properly if nsta ed upside down. _ _ BUSHING
SCREW
/
/
./
VIEW LOOKING UP
2I