Craftsman 113.206933 Owner's Manual page 14

to know your jointer.planer
A ALWAYS BE PARALLEL TO
or lrfac. _ of the w0rkpiece is
an iicati on that the OUTWARD
qFEED table is HiGH and must be
CROWNED CUT
or surface of the workpeice is
CONCAVE, it is an ind tcation that the OUTWARD
END of the fNFEED table is LOW and must be
adjusted.
Check the infeed table to determine the "out of
parallel" condition.
CONCAVE CUT
INFEED TABLE LOW
a, Insert a penciHn space at end of cutterhead to
hold cutterguard open.
b, Place astraightedge (large square or long level)
on outfeed table. First along one side than along
theother.
C. Raise infeed table until it touches straightedge.
d. Sight between tabte and straightedge to determine
high or!ow condition of end of infeed table.
= =ll
i l
] w,y
PENCIL ",
TABLE _ _-_" J__
it iseasier to adjust the infeed table while the Jointer
is setting on your workbench.
Do not turn the3ointer on its side or upside down to
adjust it.
WARNING: Attach a strip of wood to two blocks of
wood 10 in. high. Drive enough nails into thestrlp so
that Jointer does not ti p over while resting on blocks
causing possible injury,
a. Remove motor cord from outlet in switch box.
b. Remove Jointer pulley guard and V-belt.
c. Remove Jointertrom stand.
d. Place Jointer on blocks.
OF WOOD
YOUR WORK
BENCH