Mounting Switch; Installing Motor, Pulley, V-Belt And Belt Guards - Craftsman 113.206933 Owner's Manual

5. If a cutter blade adjustment is not required, check
each locking screw of each wedge (5/32" setscrew
wrench) and tighten if necessary. Hold the pulley
,i i --
MOUNTING SWITCH
1, Locate the following parts:
1 On/Off Power Outlet
2 Pan Hd. Screws, 1/4-20 x 1/2
while tightening screws and be careful that your
fingers do not slip off the wrench-
2 Lockwash_rS, IE;<te real 1/4
2 Washers, 17/64 × 1/2 x 1732
2. Attach On/Off out|et to infeed table using two _apped
holes.
i L __
INSTALLING MOTOR, PULLEY, V-BELT AND BELT
GUARDS
1. Locate the following parts:
QIy. Description
1 Motor
1 "L" Bracket
1 Pulley (Approx. 2-1/2" Dia.)
1 V=Belt 1/2 x 52
4 Carriage Bolt 5/16-18 x 3/4
4 Fiat Washer 5/16 i.D.
4 Lockwasher5/16 I.D.
4 Hex Nut 5/16-!8
1 Guard Assembly _nctuding a guard support,
guard support bracket, self-threading screws,
and clips,
2. Place motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "X" in motor mounting bracket.
DO NOT TIGHTEN BOLTS AT THiS TIME. The "L"
bracket which holds the guard support must be slid
between the motor base and the motor mounting
CARRIAGE BOLT
5/16-18 x 3/4
MOTOR ti
VtEW FROM BACK OF JOINTER
BOLTS GO THRU HOLES MARKED "X"
bracket somotor rn u st be loosely assembled to bracket
at this time.
iii, IH i, iiiiiiii, ii
(
3. Slide long leg of "L" bracket between motor base and
motor mounting bracket. Then sandwich the short leg
of the "L" bracket between the guard support bracket
and the guard support and loosely fasten together
with self-threading screws as shown. Install clips onto
bett guard support with long end of clip facing you.
L¸ i_ j ill! i
TWO HOLES CLOSEST
10-32 X 1/2 IN,
SELF-THREADING
suP.oRT
i i i i !l , i iiiiii i _ url II I
2"!/2 '° MOTOR PULLEY
4. Install the 2-1/2" pulley onto the motor shaft and
t_ghten the set screw in the pulley hub against the flat
part of the motor shaft.
5/32 INCH
SETSCREW TIGHTEN
WRENCH S_T SCREW
AGAINST FLAT
,ON SHAFT
HERE WITH
MOTOR SHAFT
9