Craftsman 113.206933 Owner's Manual page 20

5. Hold cutterhead pulley firmly with one hand and
loosen iockscreWs in each wedge using a 5/32 in.
Setscrew wrench.
BLADE
WEDGE
LIFTER LOCKSCREW
SCREW
i
5/32 IN.
SETSCREW
WRENCH
HOLD PULLEY
FIRMLY
CLOCKWISE
LOOSEN
FENCE NOT SHOWN
FOR PICTURE CLARITY
j
6. While holding Cutterhead pulley firmly with one hand,
gentlypry up each Wedge using a screwdriver . .
remove wedges and blades.
SMALL SCREWDRIVER
!
7. Remove the six lifter screws. (Two under each blade.)
8. Clean cutterhead, weoges and screws thoroughly with
Craftsman Gum and Pitch Remover. also remove the
oil from new blades.
9. Replace the six lifter screws and screw them in all the
way, but do not tighten. Mark each slot 1,2, and 3. This
witl help you in setting the blades.
CUTTER HEAD '
SETSCREW
MARK SLOTS
1, 2 AND 3X
!/8 IN. SETSCREV
WRENCH
2O