Ld Shaft Removal - Epson STYLUS 3000 Service Manual

3.2.11.15 LD Shaft Removal

1. Remove the printer mechanism unit. (See Section 3.2.6.)
2. Remove the paper eject frame unit. (See Section 3.2.11.6.)
3. Remove the CR unit. (See Section 3.2.11.14.)
4. Remove 1 screw (CBP, 3x8) securing the
mechanism with the
5. Set the release lever to the tractor side and push the
sub tractor release cam as shown in Figure 3-30 until it fits into the cutout on the left frame unit .Then
release the joint for the sub tractor cam and left frame unit.
* Release transmission lever: A black plastic lever located at the inner side of the left frame
6. Pull out the tractor release shaft along with the tractor sub release cam.
7. Remove 5 screws (CBS, 3X6) securing the base frame assembly to the printer mechanism unit. Then
remove the base frame assembly.
Rev. A
ink supplying tube unit to the tube fixing holder
tube fixing holder (B). Then release the tubes from printer mechanism.
Figure 3-29. Ink Tube Unit Removal
Figure 3-30. Base Frame Assembly Removal
EPSON Stylus COLOR 3000
release transmission lever*
on the printer
inward. Then turn the
3-33