Input Of Market Setting - Epson STYLUS 3000 Service Manual

Adjustment

4.1.2 Input of Market Setting

This operation is performed to write the market code into the EEPROM on the main control board. With
this operation, all factory values are written in at a time.
1. Connect the printer and the host computer with a parallel interface cable.
2. Start the adjustment program in the host computer.
3. The market setting menu appears. Move the cursor using
from the list and press "Return" key. An example (for EAI) is shown below:
Note
1. Unless "Market Setting" is executed, the program does not proceed to the Main menu.
2. Input of an incorrect market code will cause failure in running the program.
4. The Main menu appears on the monitor. Perform one of the followings:

Select "2. Adjustment and Check" by moving the cursor using
key. to proceed to the Adjustment and Check menu.

Select "E. END" using
1. Market
2. Adjustment & Check
3. Sensor Check

End
Select


Adjusted values are not stored in the EEPROM until the printer is turned off. Therefore, make sure
you turn off the printer once after executing the adjustment program.


The set value is transferred to the printer when each adjustment menu is complete. Therefore do
not turn off the printer before executing the menus.
4-4
<< Market Setting>>
Now :
1. C203001 (JPN)
2. C203011 (EAI)
¦
¦
H. C203161 (RUSSIA)
Select
or key to exit the program.
<<<Main>>>
(001)
WORK POINT
or key to select your marketing code
¦
¦
or
< 3. Sensor Check >
1. CR-PWS
2. ASF Quantity
3. ASF-Width
4. ASF Length
5. PG
R. Rerturn
key. Then press "Return"
Rev. A