Table of Contents
Advertisement
Disassembly and Assembly
8. Remove 1 screw (CBP, 3X8) securing the paper eject drive unit to the left main frame assembly.
9. Attach the knob to the PF roller shaft. Then hold down the
and turn the PF roller shaft until the edge guides don't lift up any further.
10. Remove the paper eject drive unit by lifting up the front part of the unit.
11. Remove the edge guide. (See 3.2.11.8.)
12. Remove 1 E-ring at the left end of the LD shaft.
13. Release the LD shaft bushing fixing the LD shaft to the
14. Release the joint for the LD gear on the right end of the LD shaft and
middle frame
unit. Then shift the LD shaft toward the left frame assembly and remove it
-
Engage the LD gear and the gear (29) in the ASF gear set as shown in Figure 3-32.
Don't touch the gear surface with your bare hands, since damage on the gear causes
decline in paper feed accuracy.
3-34
Figure 3-31. Paper Eject Drive Unit Removal
left main frame
WORK POINT
trigger lever
on the right end of the PF roller,
assembly.
ASF transmission gear
in the
Rev. A
Advertisement
Chapters
Table of Contents
