Epson STYLUS 3000 Service Manual page 131

Printer Status
Power on
Data proceeding
Paper Out
Paper Jam
Print ready
During ink sequence
No cartridge or ink
end
Ink low
Fatal error
Release lever error
Maintenance
requested
Reset

Timer reset,

Clear
 
1: Corresponding Ink End LED indicator goes on.
2: All Ink End LED indicators go on.
Rev. A
Table 5-3. LED Error Status and Solutions
Paper
Power Pause
Out
On
Blinks
On
Blinks
On
Blinks
Blinks
Blinks Blinks Blinks
All go on for 1 second.
Ink Media
End Type
After loading paper, press the
Pause button and then press
the Load/Eject button.
After removing paper, press the
Pause button and then press
the Load/Eject button.
1
On * Replace the ink cartridge.
1
B * Have a new cartridge ready.

Turn off and back on the printer.
Set the lever back to the
previous position and eject the
Blinks
loaded paper. Then set the lever
to the appropriate position for
the selected type of paper.
Replace the waste ink drain
pads
2
On* Blinks
reset. (See Section 1.4.3 and
Section 3.2.9.)
EPSON Stylus COLOR 3000
Solution
and perform
 
5-3