Interrupt Copying - Kyocera TASKalfa 180 Operation Manual

Copying Functions

Interrupt Copying

This function can be used to stop copying and to make a copy of a different original at different settings. After
the interrupt copy has been produced, the interrupted copying can be resumed at the same settings in effect
prior to the interruption.
This function can also be used to stop output of a job and to make a copy of another job. After the interrupt copy
has been produced, the interrupted job is resumed. Priority output This mode can be used to interrupt output of
a job.
The procedure for using Interrupt Copying is explained below.
4-24
1
Press the Interrupt key.
The Interrupt indicator will blink. It will stay lit when
the Interrupt operation becomes possible.
2
Store the originals for the current copying.
3
Place the originals for interrupt copying and
perform copying.
4
After the interrupt copying is complete, press the
Interrupt key. The settings for the interrupted job
are restored.
5
Replace the original with the originals that have
been stored. Press the Start key to resume
copying.
OPERATION GUIDE