3. Interrupt copying
Interrupt copying is useful if, during one copy job, other originals need
to be copied at different settings. The interrupted copy job can be
resumed at the same settings as before after the rush job is finished.
1
Press the Interrupt key to light the indicator.
The "Interrupt mode OK." screen will appear.
2
Remove the present original(s) and put it (them) aside.
3
Set the new original(s) and execute copying.
CHAPTER 4 BASIC OPERATION
4
When copying ends, press the Interrupt key again, and
replace the newly copied original(s) with the one(s) removed
before. Then, press the Start key.
The interrupted copy job will be resumed.
Approximately 120 seconds after the end of interrupt
copying, the auto clear function will be triggered. The
Interrupt indicator goes out and the copier will be ready to
resume the interrupted copy job.
4-6