Cleaning Electrical Charge Section - Kyocera TASKalfa 180 Operation Manual

Maintenance

Cleaning Electrical Charge Section

7-8
6
Place the old toner container in the plastic bag
provided for disposal.
1
While holding the charger cleaner rod, gently pull it
out as far as it will go and push it in again.
Repeat this operation two or three times.
NOTE:
Do not use excessive force to pull the rod or
attempt to pull it out completely.
2
While pushing the electrical charge section to the
right, pull it out approximately 5 cm (2 inches).
Remove the accompanying grid cleaner from its
package and remove its cap.
Fit the grid cleaner to the notch and install it into the
main body.
IMPORTANT: When installing the grid cleaner, confirm
that there is no gap between the main body and the
cleaner.
3
While holding gently the grid cleaner with your left
hand, pull out the electrical charge section to the
left as far as it will go and push it back until the
portion B does not touch the white pad of the grid
cleaner. Repeat this operation several times.
IMPORTANT: When pushing back the electrical charge
B
section, do not push it all the way into the main body.
Copying trouble may occur.
OPERATION GUIDE