Cassette Size Detection - Kyocera TASKalfa 180 Operation Manual

Preparation before Use

Cassette Size Detection

Set the Size Detection on the operation panel to match the size of the paper loaded in the cassette. The copier
has been set at the time of shipping for automatic detection in inch units for inch specifications, or in centimeter
units (A-B columns) for metric specifications.
2-6
System Menu:
19.Cassette1Size
• If the length and width guides are not flush against
the paper, a size that is different from the actual size
may be displayed on the message display.
• When the paper has become wrinkled from
moisture and cannot be fed, set the paper so that
the wrinkled side is toward the length guide.
NOTE:
When loading paper into the cassette, set it
with the side to be printed facing up.
6
Set the accompanying paper sheet so that the
paper size set in the cassette can be identified from
the front of the cassette.
7
Gently push the cassette back in.
IMPORTANT: When the machine will not be used for a
long period of time, remove the paper from the cassette,
put it in a storage bag, and seal the bag in order to
protect the paper from moisture.
1
Press the Paper Selection key for 3 seconds.
The System Menu will be displayed.
2
Press or repeatedly until
19.Cassette1Size appears, and press
key .
NOTE:
When setting the size of the optional cassette
(2 to 4), display 20.Cassette2Size,
21.Cassette3Size and 22.Cassette4Size.
3
Press to select Auto Detect mm,
or
AutoDetect inch, Oficio 2
the OK
, 8K or 16K.
OPERATION GUIDE