Language; Detect Ide; Default Menu; Original - Intergraph InterServe 8000 Setup Manual

Language

The language setting allows you to change the language used in BIOS Setup. The default is
English.

Detect IDE

The Detect IDE parameters are set to Not Installed by default. If drive C (master) is an IDE
drive, the hard disk drive parameters for drive C are detected and reported to the Pri Master
parameter in Standard Setup. If drive D (slave) is an IDE drive, the hard disk drive
parameters for drive D are detected and reported to the Pri Slave parameter in Standard
Setup. Secondary IDE drives are also supported.

Default Menu

The BIOS contains three configurations stored in CMOS RAM: Original BIOS settings,
Optimal BIOS settings, and Fail-safe BIOS settings. The Original BIOS settings are the last
current BIOS values used in the system. The Optimal BIOS settings are used in the
delivered system. The Fail-safe BIOS settings are recommended when there has been a
system failure.
NOTE Loading any of the BIOS defaults overwrites all customized parameter settings. If you have
customized any parameters, record them before loading the defaults.

Original

Selecting the Original icon loads the last current BIOS values. These values are the most
stable values that can be chosen for system performance. Use this option as a diagnostic aid
if the system is unstable.
To load the Original BIOS defaults:
1. Select the Original icon from the AMIBIOS Setup Main Menu to load the last used
BIOS settings. The following message displays:
Restore Old Values?
2. Select Yes to accept the values, or No to reject them.
3. Exit AMIBIOS Setup. The system will automatically restart with the values in effect.
89