Intergraph InterServe 8000 Setup Manual page 100

86
When set to Auto, the I/O controller selects an available address. The 3 XXh and 2XXh
values correlate to a serial port, address range and interrupt as defined by the following table.
Value
3F8h
2F8h
3E8h
2E8h
Onboard Serial Port2
This parameter enables the use of serial port 2 on the system board by selecting a memory
address for the port. The values are Auto (default), Disabled, 3F8h, 2F8h, 3E8h, and 2E8h.
When set to Auto, the I/O controller selects an available address. The 3 XXh and 2XXh
values correlate to a serial port, address range, and interrupt as defined by the following
table.
Value
3F8h
2F8h
3E8h
2E8h
Onboard Parallel Port
This parameter enables the use of the parallel port by selecting a memory address. The
values are Auto (default), Disabled, 278, 378, and 3BC. The 278, 378, and 3BC addresses
correlate to an LPT port number as defined by the following table.
Value
378
278
3BC
Parallel Port Mode
This parameter allows you to change the parallel port mode setting. The values are Normal
(default), EPP, and ECP. If this parameter is set to EPP, the EPP version parameter
displays.
Serial Port Addresses Range
COM1 3F8-3FF
COM2 2F8-2FF
COM3 3E8-3EF
COM4 2E8-2EF
Serial Port Addresses Range
COM1 3F8-3FF
COM2 2F8-2FF
COM3 3E8-3EF
COM4 2E8-2EF
Parallel Port Address Range
LPT1 378-37A
LPT2 278-27A
LPT3 3BC-3BE
Interrupts
IRQ4
IRQ3
IRQ4
IRQ3
Interrupts
IRQ4
IRQ3
IRQ4
IRQ3
Interrupt
IRQ-7 or IRQ-5
IRQ-7 or IRQ-5
IRQ-7 or IRQ-5