Light Work Clamp - Brother KE-484C Instruction Manual

14. SETTING THE WORK CLAMP MODE

14-1. Light work clamp

The hose connections can be changed so that the pressers are made to lower gently when the presser pedal is depressed to
the 1st step, and firmly when the presser pedal is depressed to the 2nd step. This makes it easier to carry out position
matching when attaching small articles such as labels.
[Memory switch setting]
Set memo-42 to 5 for two-pedal mode so that the pressers lower in the order of left then right for the standard hose
connection. (Refer to "13. Changing special functions using the memory switches".)
Hose connections for light work clamp operation by both pressers
[How to use]
1. Depress the presser pedal to the 1st step to lower the pressers and apply a light pressure. You can then position small
articles such as labels at this time.
2. After checking that everything is positioned correctly, depress the presser pedal to the 2nd step to firmly clamp the article
being sewn.
3. Press the start pedal to start sewing.
Other hose connections and corresponding operations
The hoses can be connected in combinations other than the one shown above so that only one side of the presser operates
in light work clamp mode.
Branch and plug
connectors
Branch: 1B, 2A
Plug: 1A, 2B
Branch: 1B
Plug: 2B
Branch: 1B
Plug: 2B
Branch: 2A
Plug: 1A
Branch: 2A
Plug: 1A
55
Cylinder connectors
A B C
1B 2A 1B
1B 2A 1B
1B 1A 1B
1B 2A 2B
2B 2A 1B
Operation when presser pedal is depressed to the 1st step
D
Both pressers operate in light work clamp mode
2A
(example shown above)
Only left presser lowers, and it lowers in light work clamp mode
1A
Only right presser lowers, and it lowers in light work clamp
2A
mode
Both pressers lower, but only left presser lowers in light work
2A
clamp mode
Both pressers lower, but only right presser lowers in light work
2A
clamp mode
KE-484C
Branch
Plug
3219Q