Brother KE-484C Instruction Manual page 56

<Memory switches 10 - 1F>
Switch
−
memo-10
ON when a two-stage tensioner is used.
(Special order device that outputs from option output No. 1)
memo-11
(Normally the tension opens when output is OFF, and the tension closes when option
output No. 1 is ON)
memo-12 Pneumatic wiper can be used. (Outputs from option output No. 2)
memo-13 −
−
memo-14
−
memo-15
memo-16 Needle cooler can be used. (available by special order).
memo-17
Thread take-up device is not operated at the sewing end.
memo-18
Thread take-up device operates one stitch before the sewing end.
−
memo-19
memo-1A Needle up stop position errors are not detected.
Presser can be moved up and down before the home position is detected.
memo-1b
(Normally the presser cannot be moved up and down until after the home position has
been detected.)
memo-1c −
For pneumatic specifications, the air pressure detection switch is enabled.
memo-1d
(The air pressure sensor is a special-order option.)
memo-1E Errors can be reset using the EMERGENCY STOP switch.
memo-1F
Thread is not trimmed when an emergency stop occurs during sewing.
<Memory switches 20 - 2F>
Switch
−
memo-20
Rotating-type thread breakage detector operates.
memo-21
(Device is available by special order.)
During thread breakage detection, sensitivity is decreased from 8 to 14 stitches at the
memo-22
sewing start. (Sensitivity during sewing is three stitches.)
When DIP switch A-8 is simultaneously ON, setting values changed using the operation
memo-23
panel are ignored.
memo-24 −
−
memo-25
memo-26 Enables the fiber-type thread breakage detector (when memo-21 is ON)
−
memo-27
Stores the amount of parallel movement in memory.
memo-28
(Use the memory all clear operation to clear the setting.)
memo-29
- −
memo-2F
13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
Motion when set to ON
Motion when set to ON
KE-484C
Initial value
--
--
ON
--
--
--
--
--
--
--
--
--
--
--
--
--
-- : OFF
Initial value
--
--
--
--
--
--
--
--
--
--
-- : OFF
50