Installing The Head Rest; Installing The Operation Panel - Brother KE-484C Instruction Manual

3. INSTALLATION

3-8. Installing the head rest

3-9. Installing the operation panel

The operation panel can be installed to either the top or bottom of the work table.
Top of work table
2499Q
1. Install the rear frame (1) to the work table (top or bottom) with the four wood screws (2).
* At this time, tighten the wood screws (2) until the thickness of the rubber sheet is 2 to 2.5 mm.
2. Install the front frame (3) to the rear frame (1) with the four screws (4).
* The vertical orientation of the front frame (3) is the same whether it is installed to the top or the bottom of the work table.
3. Insert the connector cord (5) into the control box through the hole at the side of the box. Refer to "3-11 Connecting the cords" for
details on connecting the cord.
4. Secure the connector cord (5) with the staples (in three places).
7
Tap the head rest (1) into the table hole.
Note:
Tap the head rest securely into the table hole.
2497Q
Bottom of work table
Table
2 - 2.5mm
KE-484C
2500Q
Table
Rubber sheet
0419Q