Operating The Foot Switch - Brother KE-484C Instruction Manual

5-2-3. Setting the sewing speed
Press the SELECT switch (6)
1
until the SPEED indicator il-
luminates.
Note:
Be sure to check the sewing pattern (refer to page 24) after setting has been completed to make sure that the needle hole does not
go out of the area circumscribed by the work clamp.

5-3. Operating the foot switch

1st step
2nd step
Press
2
switches (12) until the desired
speed setting is flashing in the
display window.
2520Q 3166Q
Start switch
Work clamp switch
0330Q
KE-484C
the DISPLAY SET
When the work clamp switch (left side) is depressed to step 1,
the work clamps on both sides are lowered.
The work clamp lowering pattern can be set to a variety of
different patterns. (Refer to "14. SETTING THE WORK CLAMP
MODE".
When the start switch (right side) is depressed, sewing starts.
5. OPERATION
22