Table of Contents
Advertisement
CHAPTER 4: PERIPHERAL CIRCUITS AND OPERATION (I/O Ports)
4.6.2 Mask option
In the I/O ports, the output specification during output mode can be selected from complementary
output and N-channel open drain output by mask option. They are selected in 1-bit units.
When N-channel open drain output is selected, do not apply a voltage exceeding the power supply
voltage to the port.
The mask option also allows selection of whether the pull-up resistor is used or not during input mode.
They are selected in 1-bit units or 4-bit units depending on the terminal group.
Ports to be selected in 1-bit units: P20, P21, P22, P23
Ports to be selected in 4-bit units: P00–P03, P10–P13, P30–P33
When "without pull-up" during the input mode is selected, take care that the floating status does not
occur.
This option is effective even when I/O ports are used for special output or input/output of the serial
interface.
4.6.3 I/O control registers and input/output mode
Input or output mode can be set for the I/O ports by writing data into the corresponding I/O control
registers IOCxx.
To set the input mode, write "0" to the I/O control register. When an I/O port is set to input mode, it
becomes high impedance status and works as an input port.
However, when the pull-up explained in the following section has been set by software, the input line is
pulled up only during this input mode.
To set the output mode, write "1" is to the I/O control register. When an I/O port is set to output mode , it
works as an output port, it outputs a high level (V
) when the port output data is "1", and a low level
DD
(V
) when the port output data is "0".
SS
If perform the read out in each mode; when output mode, the register value is read out, and when input
mode, the port value is read out.
At initial reset, the I/O control registers are set to "0", and the I/O ports enter the input mode.
The I/O control registers of the ports that are set as special output or input/output for the serial interface
can be used as general purpose registers that do not affect the I/O control. (See Table 4.6.1.1.)
4.6.4 Pull-up during input mode
A pull-up resistor that operates during the input mode is built into each I/O port of the S1C63558. Mask
option can set the use or non-use of this pull-up.
The pull-up resistor becomes effective by writing "1" to the pull-up control register PULxx that corre-
sponds to each port, and the input line is pulled up during the input mode. When "0" has been written,
no pull-up is done.
At initial reset, the pull-up control registers are set to "1".
The pull-up control registers of the ports in which "without pull-up" have been selected can be used as
general purpose registers.
Even when "with pull-up" has been selected, the pull-up control registers of the ports, that are set as
special output or output for the serial interface, can be used as general purpose registers that do not affect
the pull-up control. (See Table 4.6.1.1.)
The pull-up control registers of the port, that are set as input for the serial interface, function the same as
the I/O port.
EPSON
42
S1C63558 TECHNICAL MANUAL
Advertisement
Table of Contents
