Table of Contents
Advertisement
5.3 Precautions on Mounting
<Oscillation Circuit>
Oscillation characteristics change depending on conditions (board pattern, components used, etc.).
In particular, when a ceramic oscillator or crystal oscillator is used, use the oscillator manufacturer's
recommended values for constants such as capacitance and resistance.
Disturbances of the oscillation clock due to noise may cause a malfunction. Consider the following
points to prevent this:
(1) Components which are connected to the OSC1, OSC2, OSC3 and
OSC4 terminals, such as oscillators, resistors and capacitors,
should be connected in the shortest line.
(2) As shown in the right hand figure, make a V
possible at circumscription of the OSC1, OSC2, OSC3 and OSC4
terminals and the components connected to these terminals.
Furthermore, do not use this V
than the oscillation system.
In order to prevent unstable operation of the oscillation circuit due to current leak between OSC1/
OSC3 and V
, please keep enough distance between OSC1/OSC3 and V
DD
board pattern.
<Reset Circuit>
The power-on reset signal which is input to the RESET terminal changes depending on conditions
(power rise time, components used, board pattern, etc.).
Decide the time constant of the capacitor and resistor after enough tests have been completed with the
application product.
When the built-in pull-up resistor is added to the RESET terminal by mask option, take into consider-
ation dispersion of the resistance for setting the constant.
In order to prevent any occurrences of unnecessary resetting caused by noise during operating,
components such as capacitors and resistors should be connected to the RESET terminal in the
shortest line.
<Power Supply Circuit>
Sudden power supply variation due to noise may cause malfunction. Consider the following points to
prevent this:
(1) The power supply should be connected to the V
large as possible.
(2) When connecting between the V
should be connected as short as possible.
(3) Components which are connected to the V
connected in the shortest line.
In particular, the V
Do not connect anything to the V
S1C63558 TECHNICAL MANUAL
pattern for any purpose other
SS
and V
DD
Bypass capacitor connection example
V
DD
V
SS
–V
voltages affect the display quality.
C1
C5
–V
terminals when the LCD driver is not used.
C1
C5
pattern as large as
SS
and V
terminals with patterns as short and
DD
SS
terminals with a bypass capacitor, the terminals
SS
V
DD
V
SS
and V
–V
terminals, such as capacitors, should be
D1
C1
C5
EPSON
CHAPTER 5: SUMMARY OF NOTES
Sample V
pattern (OSC3)
SS
or other signals on the
DD
OSC4
OSC3
V
SS
157
Advertisement
Table of Contents
