H Detail Black Clip Adjustment; Detail Black Clip Adjustment - Sony Digital Betacam DVW-707 Maintenance Manual

8-16. Detail Signal Adjustment

8-16-7. H Detail Black Clip Adjustment

Note
Perform this adjustment, if necessary, to suit the custom-
er's preferences.
Preparation
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL
ITEM : TEST OUT
. OUTPUT/DCC switch (inside panel)
. Shoot a grayscale chart in the full underscanned monitor
frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
: 1 Lens IRIS
Setting point
Spec. : Open the lens iris by one step from the
reference setting
A = 100 2 IRE (NTSC)
A = 700 14 mV (PAL)
. Select the line at the center white portion of the gray-
scale chart.
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S16*LEVEL 1
ITEM : DTL H B. CLIP (Factory setting : 0)
Spec. : Set the edges of portion B to the
desired clip level.
8-22
ON
ENC
CAM/ON
A
B
8-16-8. V Detail Black Clip Adjustment
Note
Perform this adjustment, if necessary, to suit the custom-
er's preferences.
Preparation
. On the set menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : DETAIL
ITEM : TEST OUT
. OUTPUT/DCC switch (inside panel)
. Shoot a white window chart in the full underscanned
monitor frame.
Equipment : Waveform monitor
Test point : TEST OUT connector
: 1 Lens IRIS
Setting point
Spec. : Open the lens iris by one step from the
reference setting
A = 100 2 IRE (NTSC)
A = 700 14 mV (PAL)
. Select the line at the bottom of the center white portion
in the white window chart.
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S16*LEVEL 1
ITEM : DTL V B. CLIP (Factory setting : 0)
Spec. : Set the level of portion B to the desired
level.
ON
ENC
CAM/ON
A
B
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1