Int Sc Phase Adjustment - Sony Digital Betacam DVW-707 Maintenance Manual

13. On the setup menu, adjust as follows.
PAGE : S39*SG ADJ.
ITEM : H BLANKING WIDTH
: D = 10.9 ± 0.2 us (NTSC)
Spec.
D = 12.0 ± 0.3 us (PAL)
20 IRE (NTSC)
140 mV (PAL)
14. On the setup menu, set as follows. (For only NTSC)
PAGE : S39*SG ADJ.
ITEM : V BLANKING WIDTH
Spec. : 20H or 21H
A B C
1
2
3
FL12
1
4
5
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
D
D E F G
ES-23/23P board (A side)

7-4-3. INT SC Phase Adjustment

Note
The following adjustment procedures are described under
the condition by using the Tektronix 1750/1751. If any
other measuring instrument is used, perform the adjust-
ment according to the operation manual attached to it.
Preparation
. On the setup menu, set as follows.
PAGE : S24*LEVEL 7
ITEM : TEST OUT
Adjustment Procedure
Equipment : Waveform/Vector monitor
(SC-H Phase measuring mode)
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S28*LEVEL 11
ITEM : SC PHASE
Spec. : Coincide the beam spot of the burst
(SC) with the direction of the beam
spot of H.
M
G
R
Y
L
B
G
C
Y
(For NTSC)
Setting After Adjustment
Connect the waveform monitor to the TEST OUT connec-
tor.
7-4. ENC OUT Adjustment
ENC
R
M
G
Y
L
B
G
C
Y
(For PAL)
7-9