Sony Digital Betacam DVW-707 Maintenance Manual page 168

4-2. Parts Replacement
Installation
2. Detection Pins Installation
Attach the detection pins to the sensor cover (B) in
the direction shown in the figure.
n
When attaching the sensor cover (B), to prevent
from the falling, it recommends that the adhesive
tape is put on the position shown in the figure. Af-
ter carrying out step 3, peel off and check that the
adhesive tape is not put on the outer circumference
of the detection pins.
3. Sensor Cover (B) Installation
Put the two bosses and the two hooks of the sensor
cover (B) in the four holes on the SE-210 board in
the sequence of the figure and attach.
4. Operation Check
Check that the detection pins move freely in the
direction of vertical and return it back into the posi-
tion.
4-84
Detection
pins
Adhesive tape
3 (Claw)
Sensor cover (B)
Adhesive tape
Sensor cover (B)
2 (Claw)
1 Boss
DVW-790WS/709WS/707 P2V1
DVW-790WSP/709WSP/707P P2V1