Other Status Read Commands; Cr_Status Command; Cr_Signal Command; Cr_Vmute Command - Sanyo PLV-WF20 - 6000 Lumens Manual

PLV-WF20 Expand Serial Command Functional Specifications

9.11 Other Status Read Commands

9.11.1 CR_STATUS Command

Command "CR_STATUS" [CR]
Get operating status of Projector
Details
Same as "CR0" in basic command except error code follows it.
Acceptable
Response
Unacceptable

9.11.2 CR_SIGNAL Command

Command "CR_SIGNAL" [CR]
Details Get status if there is any signal or not
Acceptable
Response
Unacceptable

9.11.3 CR_VMUTE Command

Command "CR_VMUTE" [CR]
Details Get Video mute setting status
Acceptable
Response
Unacceptable

9.11.4 CR_FREEZE Command

Command "CR_FREEZE" [CR]
Details Get Freeze setting status
Acceptable
Response
Unacceptable
"000_%1" [CR]
"00" = Power ON
"80" = Standby
"40" = Countdown in process
"20" = Cooling Down in process
"10" = Power Failure
"28" = Cooling Down in process due to abnormal temperature
"88" =Standby after Cooling Down due to abnormal temperature
"02" = Invalid RS-232C Command
%1
"24" = Power Save/Cooling Down in process
"04" = Power Save
"21" = Cooling Down in process after turned Off due to lamp
failure
"81"＝ Standby after Cooling Down due to lamp failure
"2C" = Cooling Down in process after Power Off due to
Shutter management
"8C" = Standby after Cooling Down due to Shutter management
"Error Code" [CR]
"000_%1" [CR]
"ON" -------------------------- There is signal
%1
"OFF" ------------------------ There is no signal
"?" [CR]
"000_%1" [CR]
"ON" ------------------------ Video mute is set to ON (Shutter Close).
%1
"OFF" ---------------------- Video mute is set to OFF (Shutter Open).
"?" [CR]
"000_%1" [CR]
"ON" ---------------------------- Freeze is set to ON.
%1
"OFF" -------------------------- Freeze is set to OFF.
"?" [CR]
64/68