PDG-DWL100 Expand Serial Command Functional Specifications
9.12 Other Status Read Commands
9.12.1 CR_STATUS Command
Command
"CR_STATUS" [CR]
Get status of Projector.
Details
This command is the same as "CR0" of Basic command, but it returns an
error code.
Acceptable
Correspondence
Unacceptable
9.12.2 CR_SIGNAL Command
Command
"CR_SIGNAL" [CR]
Details
Get status if there is any signal or not
Acceptable
Correspondence
Unacceptable
9.12.3 CR_VMUTE Command
Command
"CR_VMUTE" [CR]
Details
Get No Show setting status
Acceptable
Correspondence
Unacceptable
9.12.4 CR_FREEZE Command
Command
"CR_FREEZE" [CR]
Details
Get Freeze setting status
Acceptable
Correspondence
Unacceptable
"000_%1" [CR]
"00" = Power on
"80"= Standby
"20"= Cooling
%1
"10"= Power Error
"28"= Temperature Error cooling
"21"= Cooling after Lamp Error
"?" [CR]
"000_%1" [CR]
"ON" -------------------------- There is signal
%1
"OFF" ------------------------ There is no signal
"?" [CR]
"000_%1" [CR]
"ON" ----------------------------- No Show is ON.
%1
"OFF" --------------------------- No Show is OFF.
"?" [CR]
"000_%1" [CR]
"ON" ---------------------------- Freeze is ON.
%1
"OFF" -------------------------- Freeze is OFF.
"?" [CR]
45 / 47