Cf_H - Pos Command; Cf_V - Pos Command; Cf_Ddots Command - Sanyo PLC-WU3800 Manual

PLC-WU3800 Expand Serial Command Functional Specifications
8.5.4 CF_H – POS Command
Command "CF_H-POS_%1"[CR]
"0000~nnnn" --- Directly select Horizontal Position setting value
"nnnn" shows maximum value, it is current Total Dots value - Display Dots value
%1
"UP" -------------- Current Horizontal Position setting value + 1
"DN" -------------- Current Horizontal Position setting value - 1
Set Horizontal Position value of PC signal.
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.5 CF_V – POS Command
Command "CF_V-POS_%1"[CR]
"0000~nnnn" --- Directly select Vertical Position setting value
%1
"UP" -------------- Current Vertical Position setting value + 1
"DN" -------------- Current Vertical Position setting value – 1
Set Vertical Position value of PC signal
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.6

CF_DDOTS Command

Command "CF_DDOTS_%1"[CR]
"0256"~"nnnn" --- Directly select Display Dots setting value
%1
"UP" -------------- Current Display Dots setting value + 2
"DN" -------------- Current Display Dots setting value – 2
Set Display Dots value of PC signal
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"101"[CR] ---- when Input for Video is selected
"nnnn" shows maximum value, it is current Total Line value - Display Line value
"000"[CR]
"101"[CR] ---- When Input source is Video system
"nnnn" shows maximum value, it is current Total Dots value - Horizontal
Position value
Even number is available and when odd number is set, it is rounded out.
"000"[CR]
"101"[CR] ---- When Input for Video is selected
23/74