NetComm NCT240 Management Guide
SNMP
This command is for configuring SNMP agent:
Syntax:
snmp <show|getcommunity|setcommunity|trapcommunity>
show
getcommunity
setcommunity
trapsetting
Command usage:
snmp show
snmp getcommunity <getcommunity>
snmp setcommunity <setcommunity>
trapsetting <trap community> <trap receiver IP> <trap port>
Server
Syntax: server <show| enable <telnet| ftp| web| ssh>|disable <telnet |ftp| web| ssh>|
port>
show – display current server service status.
enable – open the telnet, ftp, web or ssh server service
disable – close the telnet, ftp, web or ssh server service
port – show the port of a service
Command usage:
BAS/sys>server
The device's service status and port numbers information
Usage:
server <show| enable| disable| port><telnet| ftp| web| ssh>
show
enable Turn on a service.
disable Turn off a service.
port
Show the port of a service.
Display SNMP settings.
Set the SNMP GetRequest community.
Set the SNMP SetRequest community.
Set the SNMP TrapCommunity, trapIP, trapPort.
Display the device's service status and port numbers.
server command
Release 1.0
42