Table of Contents
Advertisement
NetComm NCT240 Management Guide
Looptest
Using this command you can diagnostic this device through four ways loops.
Syntax: looptest <ingutopia|egutopia|ingge0|egge0|disable>
ingutopia - LoopLine Interface, UTOPIA Ingress Loop enable
egutopia - LoopLine Interface, UTOPIA Egress Loop enable
ingge0 - System Interface, LAN Interface Ingress Loop enable
egge0 - System Interface, LAN Interface Egress Loop enable
disable - All Loop disable
IP:
A set of IP commands may be used for management access to NCT240 over your
network.
help
Display command list
?
Display command list
show
arp
Display, flush the device ARP table
set
Set the management ip address and subnet mask and mac address
gateway
Set the default gateway of the device's default gateway
route
The routing table.
ping
Ping a remote host
exit
Return to upper level
show
Syntax: show
show – displays the IP settings for this device
Display the management ip address settings
IP command list
Release 1.0
58
Advertisement
Table of Contents
